Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for LHD) › from 2016.05
RM24M0E _56 Audio / Visual / Telematics _059590 PARK ASSIST / MONITORING _0292209 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for LHD) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for LHD)  Taillight Circuit  


WIRING DIAGRAM

E256012E03
4.467,1.4 5.041,1.575 0.575,0.174 10 G108 4.467,1.559 6.645,1.734 2.179,0.174 10 Clearance Warning ECU Assembly 5.207,0.858 5.404,1.032 0.196,0.174 10 TL 4.94,0.755 5.114,0.930 0.174,0.174 10 20 0.733,0.84 1.755,1.015 1.022,0.174 10 from TAIL Relay 3.342,0.984 3.818,1.158 0.476,0.174 10 PANEL

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK TAILLIGHT
a.

Check that the taillight comes on when the light control switch to the tail or head position.


b.

Check that the taillight turns on.

OK:

Taillight turns on.




OK

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the G108 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) is the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G108-20 (TL) - Body ground Engine switch on (IG)
Light control switch in the tail or head position
11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR