Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for LHD) › from 2016.05
RM24M0E _56 Audio / Visual / Telematics _059590 PARK ASSIST / MONITORING _0292209 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for LHD) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for LHD)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E274582E11
0.51,0.708 1.865,0.948 1.354,0.24 10 false from LH-IG Relay 2 2.531,0.865 3.448,1.031 0.917,0.167 10 false GAUGE NO.1 5.083,2 5.5,2.188 0.417,0.188 10 false G108 5.094,2.167 6.625,2.563 1.531,0.396 10 false Clearance Warning ECU Assembly 5.229,0.594 5.479,0.76 0.25,0.167 10 false 11 5.229,1.365 5.479,1.531 0.25,0.167 10 false 16 5.5,1.479 5.667,1.646 0.167,0.167 10 false E 5.5,0.698 5.667,0.896 0.167,0.198 10 false IG

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)
a.

Disconnect the G108 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) is the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G108-11 (IG) - Body ground Engine switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G108-16 (E) - Body ground Always Below 1 Ω




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR