Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD) › from 2016.05
RM24M0E _56 Audio / Visual / Telematics _059590 PARK ASSIST / MONITORING _0292210 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E348210E06
5.01,2.177 6.531,2.573 1.521,0.396 10 false Clearance Warning ECU Assembly 5.521,1.49 5.708,1.729 0.188,0.24 10 false E 5.5,0.708 5.813,0.906 0.313,0.198 10 false IG 2.573,0.854 3.438,1.073 0.865,0.219 10 false RH ECU-IG 0.5,0.698 1.875,0.896 1.375,0.198 10 false from RH-IG Relay 1 5.302,0.604 5.458,0.802 0.156,0.198 10 false 1 5.24,1.385 5.552,1.583 0.313,0.198 10 false 30 5.01,2 5.469,2.198 0.458,0.198 10 false G111

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)
a.

Disconnect the G111 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) is the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G111-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V
G111-1 (IG) - Body ground Engine switch off Below 1 V




OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G111-30 (E) - Body ground Always Below 1 Ω




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR