MALFUNCTION DISPLAY (MULTI-INFORMATION DISPLAY)
Open circuit indication
If there is an open circuit between a ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.
If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
Frozen indication
If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.
If a frozen indication is displayed, read Precaution for TOYOTA Parking Assist-sensor System first and confirm that the sensor is not covered with foreign matter (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>PRECAUTION).
Check for DTCs and troubleshoot according to each inspection procedure after confirming that the sensor is not covered with foreign matter (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
DETECTION RANGE MEASUREMENT AND DISPLAY INSPECTION
The following measurement and inspection will be performed with the shift lever in a position other than P. Be sure to apply the parking brake and depress the brake pedal firmly to prevent the vehicle from moving.
Turn the engine switch on (IG).
Turn the clearance sonar main switch (combination switch assembly) on.
Detection range measurement:
When measuring the detection range of the front corner sonar, move the shift lever to any position other than P.
When measuring the detection range of the rear corner sonar and rear center sonar, move the shift lever to R.
Move a 60 mm (2.4 in.) diameter pole near each sensor to measure its detection range.
These detection ranges are applicable when positioning the 60 mm (2.4 in.) diameter pole parallel or perpendicular to the ground. The detection range varies depending on the measuring method and type of obstacle (such as walls).
Have an assistant move the pole.
The ultrasonic sensor side view detection range (hatched area labeled (B)) represents the cross section of the top view detection range (A). The hatched area (B) does not represent the entire side view detection range.
Front corner sonar display and buzzer operation check
When the front corner ultrasonic sensors have detected an obstacle, check the displays and check that the buzzer sounds.
| Engine Switch | Clearance Sonar Main Switch (Combination Switch Assembly) | Shift Lever Position | Vehicle Speed |
|---|---|---|---|
| On (IG) | On | In any position other than P | 10 km/h (6 mph) or less |
| On (IG) | On | R | - |
| Detection Range | During Judgment | Obstacle |
|---|---|---|
| Close-range detection
Within approx. 300 +/- 30 mm (11.8 +/- 1.2 in.) |
Buzzer: Sounds continuously
Number of bars displayed: 1 (blinking) |
60 mm (2.4 in.) diameter pole |
| Medium-range detection
From approx. 300 +/- 30 to 450 +/- 50 mm (11.8 +/- 1.2 to 17.7 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.1 sec. / OFF: 0.1 sec.)
Number of bars displayed: 2 (illuminated) |
60 mm (2.4 in.) diameter pole |
| Long-range detection
From approx. 450 +/- 50 to 600 +/- 60 mm (17.7 +/- 2.0 to 23.6 +/- 2.4 in.) |
Buzzer: Sounds intermittently (ON: 0.2 sec. / OFF: 0.2 sec.)
Number of bars displayed: 3 (illuminated) |
60 mm (2.4 in.) diameter pole |
Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.
Rear corner sonar display and buzzer operation check
When the front corner ultrasonic sensors have detected an obstacle, check the display and check that the buzzer sounds.
| Engine Switch | Clearance Sonar Main Switch (Combination Switch Assembly) | Shift Lever Position | Vehicle Speed |
|---|---|---|---|
| On (IG) | On | R | - |
| Detection Range | During Judgment | Obstacle |
|---|---|---|
| Close-range detection
Within approx. 300 +/- 30 mm (11.8 +/- 1.2 in.) |
Buzzer: Sounds continuously
Number of bars displayed: 1 (blinking) |
60 mm (2.4 in.) diameter pole |
| Medium-range detection
From approx. 300 +/- 30 to 450 +/- 50 mm (11.8 +/- 1.2 to 17.7 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.1 sec. / OFF: 0.1 sec.)
Number of bars displayed: 2 (illuminated) |
60 mm (2.4 in.) diameter pole |
| Long-range detection
From approx. 450 +/- 50 to 600 +/- 60 mm (17.7 +/- 2.0 to 23.6 +/- 2.4 in.) |
Buzzer: Sounds intermittently (ON: 0.2 sec. / OFF: 0.2 sec.)
Number of bars displayed: 3 (illuminated) |
60 mm (2.4 in.) diameter pole |
Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.
Rear center sonar display and buzzer operation check
When the rear center ultrasonic sensors have detected an obstacle, check the display and check that the buzzer sounds.
| Engine Switch | Clearance Sonar Main Switch (Combination Switch Assembly) | Shift Lever Position | Vehicle Speed |
|---|---|---|---|
| On (IG) | On | R | - |
| Detection Range | During Detection | Obstacle |
|---|---|---|
| Close-range detection
Within approx. 350 +/- 40 mm (13.8 +/- 1.6 in.) |
Buzzer: Sounds continuously
Number of bars displayed: 1 (blinking) |
60 mm (2.4 in.) diameter pole |
| Medium-range detection
From approx. 350 +/- 40 to 450 +/- 50 mm (13.8 +/- 1.6 to 17.7 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.1 sec. / OFF: 0.1 sec.)
Number of bars displayed: 2 (illuminated) |
60 mm (2.4 in.) diameter pole |
| Long-range detection
From approx. 450 +/- 50 to 600 +/- 60 mm (17.7 +/- 2.0 to 23.6 +/- 2.4 in.) |
Buzzer: Sounds intermittently (ON: 0.2 sec. / OFF: 0.2 sec.)
Number of bars displayed: 3 (illuminated) |
60 mm (2.4 in.) diameter pole |
| Longest-range detection
From approx. 600 +/- 60 to 1500 +/- 150 mm (23.6 +/- 2.4 to 59.1 +/- 5.9 in.) |
Buzzer: Sounds intermittently (ON: 0.2 sec. / OFF: 0.5 sec.)
Number of bars displayed: 4 (illuminated) |
Wall |
Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.