1.CUSTOMIZE TOYOTA PARKING ASSIST-SENSOR SYSTEM
Customizing with the GTS
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the clearance sonar main switch (combination switch assembly) on.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Sonar / Utility / Customize.
Select the setting by referring to the table below.
| Display | Default | Content | Setting |
|---|---|---|---|
| Rr Sensor Onset Range | Wide | Sets the buzzer activation range for the rear center sensors. | Narrow or Wide
·
Narrow: 600 mm (23.6 in.) ·
Wide: 1500 mm (59.1 in.) |
| Keep Sense Buzzer | Avail | Sounds the buzzer when the distance between the vehicle and an obstacle does not change for more than 3 seconds. | Not Avail or Avail
·
Not Avail: Not Available ·
Avail: Available |
| Fr & Rr Buzzer Volume | H | Changes the buzzer volume setting. | L, M1, M2, M3 or H
·
L: Low volume ·
M1: Medium low volume ·
M2: Medium volume ·
M3: Medium high volume ·
H: High volume |
| Temporary Mute Reset Speed Adjust* | 20 km/h | Sets the vehicle speed at which the temporary mute function resets. | System Link,15 km/h, 20 m/h or 30 km/h
·
System Link: System Link ·
15 km/h: 15 km/h (9 mph) ·
20 km/h: 20 km/h (12 mph) ·
30 km/h: 30 km/h (19 mph) |
| Temporary Mute Function* | ON | Sets the availability of the temporary mute function. | ON or OFF
·
ON: Temporary Mute Function operating ·
OFF: Temporary Mute Function not operating |
*: Not applicable
| Display | Default | Content | Setting |
|---|---|---|---|
| Sensor Condition N | Avail | Makes the front sensors available when the shift lever is in N. | Not Avail or Avail
·
Not Avail: Not Available ·
Avail: Available |
| Reverse Range Front Sensor | F | Changes the operation setting for the front sensors when the shift lever is in R. | F or F Stop
·
F: Front sensors are available ·
F Stop: Front sensors are not available |
| Non P/R Range Rear Sensor | R Stop | Changes the operation setting for the rear sensors when the shift lever is in any position other than P or R. | R, Rcrn or R Stop
·
R: All rear sensors are available ·
Rcrn: Rear corner sensors are available ·
R Stop: All rear sensors are not available |
| Display | Default | Content | Setting |
|---|---|---|---|
| Display Mode* | All | The display mode setting (when the TOYOTA parking assist-sensor system is normal). | All or Undisp
·
All: Display displays all sensors ·
Undisp: Display does not display |
*: Not applicable