Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292216 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)  


DESCRIPTION

If the door glass or the power window regulator motor does not operate smoothly, the jam protection function may be triggered automatically, resulting in the AUTO UP function being unable to fully close the window.

HINT:

This symptom may occur for all the windows.


PROCEDURE

1.PERFORM INITIALIZATION
a.

Initialize the power window regulator motor assembly (see page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


b.

Check that the power window operates normally by opening and closing the window.

OK:

AUTO UP / DOWN function operates normally.




NG

2.CHECK WINDOW GLASS SLIDING MOVEMENT

OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

2.CHECK WINDOW GLASS SLIDING MOVEMENT
a.

Remove the window regulator.


b.

Install the window glass onto the door glass run.


c.

Check if the door window regulator operates smoothly.


d.

Check that the window glass slides smoothly when sliding it up by hand.

OK:

Door window glass slides smoothly.


HINT:

Ensure the following:

·

The window glass fits with the glass run without improper contact.

·

Neither deformation nor foreign matter in the glass run.



CAUTION:

Perform initialization again.




OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)

NG

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FITTING OR REPLACE PARTS)