Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292216 POWER WINDOW CONTROL SYSTEM U

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the tester ON.


c.

Select the following menu items: Body / Master Switch / Data List.


d.

Check the results by referring to the table below.

Multiplex network master switch
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver side power window AUTO UP / DOWN switch signal / ON or OFF ON: Driver side power window switch operates (AUTO operation)
OFF: Driver side power window switch does not operate
-
P Door P/W Auto SW Front passenger side power window AUTO UP / DOWN switch signal / ON or OFF ON: Front passenger side power window switch operates (AUTO operation)
OFF: Front passenger side power window switch does not operate
-
RL Door P/W Auto SW Rear LH power window AUTO UP / DOWN switch signal / ON or OFF ON: Rear LH power window switch operates (AUTO operation)
OFF: Rear LH power window switch does not operate
-
RR Door P/W Auto SW Rear RH power window AUTO UP / DOWN switch signal / ON or OFF ON: Rear RH power window switch operates (AUTO operation)
OFF: Rear RH power window switch does not operate
-
P Door P/W Up SW Front passenger side power window MANUAL UP switch signal / ON or OFF ON: Front passenger side power window switch operates (MANUAL UP operation)
OFF: Front passenger side power window switch does not operate
-
RL Door P/W Up SW Rear LH power window MANUAL UP switch signal / ON or OFF ON: Rear LH power window switch operates (MANUAL UP operation)
OFF: Rear LH power window switch does not operate
-
RR Door P/W Up SW Rear RH power window MANUAL UP switch signal / ON or OFF ON: Rear RH power window switch operates (MANUAL UP operation)
OFF: Rear RH power window switch does not operate
-
P Door P/W Down SW Front passenger side power window MANUAL DOWN switch signal / ON or OFF ON: Front passenger side power window switch operates (MANUAL DOWN operation)
OFF: Front passenger side power window switch does not operate
-
RL Door P/W Down SW Rear LH power window MANUAL DOWN switch signal / ON or OFF ON: Rear LH power window switch operates (MANUAL DOWN operation)
OFF: Rear LH power window switch does not operate
-
RR Door P/W Down SW Rear RH power window MANUAL DOWN switch signal / ON or OFF ON: Rear RH power window switch operates (MANUAL DOWN operation)
OFF: Rear RH power window switch does not operate
-
Window Lock Switch Status Window lock switch signal / ON or OFF ON: Window lock switch LOCK position
OFF: Window lock switch UNLOCK position
-


e.

Select the following menu items: Body / D-Door Motor / Data List.


f.

Check the results by referring to the table below.

Driver side power window regulator motor (Power window ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver side power window AUTO UP / DOWN switch signal / ON or OFF ON: Driver side power window switch operates (AUTO operation)
OFF: Driver side power window switch does not operate
-
D Door P/W Up SW Driver side power window MANUAL UP switch signal / ON or OFF ON: Driver side power window switch operates (MANUAL UP operation)
OFF: Driver side power window switch does not operate
-
D Door P/W Down SW Driver side power window MANUAL DOWN switch signal / ON or OFF ON: Driver side power window switch operates (MANUAL DOWN operation)
OFF: Driver side power window switch does not operate
-
Glass Pos - 1/4 Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 2/4 Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 3/4 Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - Open Margin for jam protection triggering force of window glass within range of 3/4 to fully open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-


g.

Select the following menu items: Body / P-Door Motor / Data List.


h.

Check the results by referring to the table below.

Front passenger side power window regulator motor (Power window ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
P Door P/W Auto SW Front passenger side power window AUTO UP / DOWN switch signal / ON or OFF ON: Front passenger side power window switch operates (AUTO operation)
OFF: Front passenger side power window switch does not operate
-
P Door P/W Up SW Front passenger side power window MANUAL UP switch signal / ON or OFF ON: Front passenger side power window switch operates (MANUAL UP operation)
OFF: Front passenger side power window switch does not operate
-
P Door P/W Down SW Front passenger side power window MANUAL DOWN switch signal / ON or OFF ON: Front passenger side power window switch operates (MANUAL DOWN operation)
OFF: Front passenger side power window switch does not operate
-
Glass Pos - 1/4 Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 2/4 Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 3/4 Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - Open Margin for jam protection triggering force of window glass within range of 3/4 to fully open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-


i.

Select the following menu items: Body / RL-Door Motor / Data List.


j.

Check the results by referring to the table below.

Rear LH power window regulator motor (Power window ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RL Door P/W Auto SW Rear LH power window AUTO UP / DOWN switch signal / ON or OFF ON: Rear LH power window switch operates (AUTO operation)
OFF: Rear LH power window switch does not operate
-
RL Door P/W Up SW Rear LH power window MANUAL UP switch signal / ON or OFF ON: Rear LH power window switch operates (MANUAL UP operation)
OFF: Rear LH power window switch does not operate
-
RL Door P/W Down SW Rear LH power window MANUAL DOWN switch signal / ON or OFF ON: Rear LH power window switch operates (MANUAL DOWN operation)
OFF: Rear LH power window switch does not operate
-
Glass Pos - 1/4 Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 2/4 Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 3/4 Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - Open Margin for jam protection triggering force of window glass within range of 3/4 to fully open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-


k.

Select the following menu items: Body / RR-Door Motor / Data List.


l.

Check the results by referring to the table below.

Rear RH power window regulator motor (Power window ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RR Door P/W Auto SW Rear RH power window AUTO UP / DOWN switch signal / ON or OFF ON: Rear RH power window switch operates (AUTO operation)
OFF: Rear RH power window switch does not operate
-
RR Door P/W Up SW Rear RH power window MANUAL UP switch signal / ON or OFF ON: Rear RH power window switch operates (MANUAL UP operation)
OFF: Rear RH power window switch does not operate
-
RR Door P/W Down SW Rear RH power window MANUAL DOWN switch signal / ON or OFF ON: Rear RH power window switch operates (MANUAL DOWN operation)
OFF: Rear RH power window switch does not operate
-
Glass Pos - 1/4 Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 2/4 Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - 3/4 Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-
Glass Pos - Open Margin for jam protection triggering force of window glass within range of 3/4 to fully open position / OK or CAUTION OK: Margin is sufficient during manual UP operation
CAUTION: May be displayed even when no resistance is applied in each position. In this case, there is a foreign matter stuck in that position.
-


m.

Select the following menu items: Body / Body ECU / Data List.


n.

Check the results by referring to the table below.

Main body ECU
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Communication D-Door Motor Connection status between power window regulator motor (for driver side) and main body ECU / OK or STOP OK: Connection
Stop: No connection
-
Communication P-Door Motor Connection status between power window regulator motor (for front passenger side) and main body ECU / OK or STOP OK: Connection
Stop: No connection
-
Communication RL-Door Motor Connection status between power window regulator motor (for rear LH) and main body ECU / OK or STOP OK: Connection
Stop: No connection
-
Communication RR-Door Motor Connection status between power window regulator motor (for rear RH) and main body ECU / OK or STOP OK: Connection
Stop: No connection
-
Communication Master SW Connection status between multiplex network master switch and main body ECU / OK or STOP OK: Connection
Stop: No connection
-
D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON: Driver door open
OFF: Driver door closed
-
P Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger door open
OFF: Front passenger door closed
-



PERFORM ACTIVE TEST


HINT:

Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the tester ON


c.

Select the following menu items: Body / D-Door Motor / Active Test.


d.

Perform the Active Test by referring to the table below.

NOTICE:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.


Driver side power window regulator motor (Power window ECU)
Tester Display Test Part Control Range
Power window UP / OFF (OFF) -
Power window DOWN / OFF (OFF) -


e.

Select the following menu items: Body / P-Door Motor / Active Test.


f.

Perform the Active Test by referring to the table below.

NOTICE:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.


Front passenger side power window regulator motor (Power window ECU)
Tester Display Test Part Control Range
Power window UP / OFF (OFF) -
Power window DOWN / OFF (OFF) -


g.

Select the following menu items: Body / RL-Door Motor / Active Test.


h.

Perform the Active Test by referring to the table below.

NOTICE:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.


Rear LH power window regulator motor (Power window ECU)
Tester Display Test Part Control Range
Power window UP / OFF (OFF) -
Power window DOWN / OFF (OFF) -


i.

Select the following menu items: Body / RR-Door Motor / Active Test.


j.

Perform the Active Test by referring to the table below.

NOTICE:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.


Rear RH power window regulator motor (Power window ECU)
Tester Display Test Part Control Range
Power window UP / OFF (OFF) -
Power window DOWN / OFF (OFF) -