Customizing with the GTS
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Power Window.
Select the setting by referring to the table below.
| Tester Display | Default | Content | Setting |
|---|---|---|---|
| Door Key P/W Up | OFF | Function to close the power windows using the mechanical key | OFF / ON |
| Door Key P/W Down | OFF | Function to open the power windows using the mechanical key | OFF / ON |
| P/W Up W/ Transmit | OFF | Function to close the power windows using the electrical key transmitter sub-assembly | OFF / ON |
| P/W Down W/ Transmit | OFF | Function to open the power windows using the electrical key transmitter sub-assembly | OFF / ON |
| P/W Up w/ Smart* | OFF | Function that raises all power windows when, with power switch off, entry lock switch on driver door outer handle is pressed and held for more than 3.0 seconds. | OFF / ON |
*: w/ Entry Lock Switch-linked Close Function