If the manual UP / DOWN function can be performed but the AUTO UP / DOWN function cannot, then the fail-safe may be functioning.
If the power window initialization (see page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION) has not been performed, the AUTO UP / DOWN function will not operate.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Body ECU / Data List.
Read the display on the tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Communication D-Door Motor | Connection status between power window regulator motor (driver side) and main body ECU / OK or STOP | OK: Connection
Stop: No connection |
- |
OK is displayed on the intelligent tester screen.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Master Switch / Data List.
Read the display on the tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door P/W Auto SW | Driver side power window AUTO UP / DOWN switch signal / ON or OFF | ON: Driver side power window switch operates (AUTO operation)
OFF: Driver side power window switch does not operate |
- |
ON is displayed on the intelligent tester screen during AUTO operation.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / D-Door Motor / Data List.
Read the display on the tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door P/W Auto SW | Driver side power window AUTO UP / DOWN switch signal / ON or OFF | ON: Driver side power window switch operates (AUTO operation)
OFF: Driver side power window switch does not operate |
- |
ON is displayed on the intelligent tester screen during AUTO operation.
OK
NG