Home › Vehicle Interior › EXTERIOR › FRONT PILLAR UPPER COVER
RM24M0E _58 Vehicle Interior _059595 EXTERIOR _0292241 FRONT PILLAR UPPER COVER A

EXTERIOR  FRONT PILLAR UPPER COVER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

·

Continue drilling and push out the remaining rivet fragments.

·

Using a vacuum cleaner, remove the rivet fragments and shavings from the pillar.



PROCEDURE

Hide 75534 1.REMOVE WINDSHIELD MOULDING OUTSIDE

B146314E05
2.292,0.802 2.688,0.802 false 1.302,0.729 2.313,0.906 1.01,0.177 10 false Protective Tape

a.

Put protective tape around the pillar.


b.

Detach the 7 claws.


c.
B146315

Move the moulding in the direction of the arrow shown in the illustration to detach the claw.


d.
B146316

Move the moulding in the direction of the arrow shown in the illustration and remove the moulding.


Hide 75545B 2.REMOVE NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

B142000E04
0.414,0.873 0.837,1.039 0.423,0.165 10 5 mm

a.

Using a drill bit with a diameter of less than 5 mm (0.20 in.), drill out the rivet heads and remove the clip.


Hide 75545B 3.REMOVE NO. 2 WINDSHIELD OUTSIDE MOULDING CLIP

B142001E01
0.553,1.019 0.976,1.184 0.423,0.165 10 5 mm

a.

Using a drill bit with a diameter of less than 5 mm (0.20 in.), drill out the 6 rivets heads and remove the 3 clips.


Hide 75545B 4.REMOVE NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

B142002E01
0.651,0.533 1.048,0.709 0.397,0.177 10 5 mm

a.

Using a drill bit with a diameter of less than 5 mm (0.20 in.), drill out the rivet heads and remove the 2 clips.


Hide 75545B 5.REMOVE NO. 4 WINDSHIELD OUTSIDE MOULDING CLIP

B142004

a.

Detach the 3 clips.