53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 5 clips and upper radiator support seal.
53101
2.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Put protective tape around the radiator grille sub-assembly.
Remove the 2 screws and clip.
Disengage the 6 claws and remove the radiator grille sub-assembly.
3.REMOVE FRONT BUMPER ASSEMBLY
Put protective tape around the front bumper assembly.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
Use the same procedure for the RH side and LH side.
Remove the screw.
Use the same procedure for the RH side and LH side.
Remove the 3 screws, 4 bolts and 4 clips.
Remove the 3 clips.
Disengage the 6 claws and remove the front bumper assembly as shown in the illustration.
Disconnect the connector.