52114A
1.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Type A)
Remove the 2 screws.
Disengage the 2 claws and remove the front bumper extension mounting bracket.
52114A
2.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Type B)
Remove the 2 screws.
Disengage the 3 guides and remove the front bumper extension mounting bracket as shown in the illustration.
53155D
3.REMOVE NO. 1 RADIATOR GRILLE SEAL
Disengage the 2 clips, and remove the No. 1 radiator grille seal.
Remove the hood to front end panel seal.
53145B
4.REMOVE RADIATOR GRILLE GARNISH CLIP
Remove the 2 radiator grille garnish clip.
53396D
5.REMOVE RADIATOR GRILLE SEAL
Remove the 2 radiator grille seals.
75311
6.REMOVE RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
Disengage the 3 claws and remove the radiator grille emblem.
85376B
7.REMOVE HEADLIGHT CLEANER WASHER HOSE (w/ Headlight Cleaner System)
85045
8.REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY (w/ Headlight Cleaner System)
85208A
9.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY (w/ Headlight Cleaner System)
81220
10.REMOVE FOG LIGHT ASSEMBLY LH
81210A
11.REMOVE FOG LIGHT ASSEMBLY RH
Use the same procedures for the RH side and LH side.
81482E
12.REMOVE FOG LIGHT BRACKET LH
Remove the clip.
Remove the 2bolt to fog light bracket LH.
81481G
13.REMOVE FOG LIGHT BRACKET RH
Use the same procedure for the RH side and LH side.
53112E
14.REMOVE LOWER NO. 1 RADIATOR GRILLE
Disengage the 17 claws to remove the lower No. 1radiator grille.
52128B
15.REMOVE FRONT BUMPER HOLE COVER LH (w/ Cover)
Disengage the 3 claws to remove the front bumper hole cover LH.
52127D
16.REMOVE FRONT BUMPER HOLE COVER RH (w/ Cover)
Use the same procedure for the RH side and LH side.
89341K
17.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ Clearance Sonar System)
82114
18.REMOVE NO. 4 ENGINE ROOM WIRE
Disengage the 10 clamps to remove the NO. 4 engine room wire.
52127C
19.REMOVE FRONT BUMPER HOLE COVER
Disengage the 2 claws and remove the front bumper hole cover.
Use the same procedure for the RH side and LH side.
52116A
20.REMOVE FRONT BUMPER SIDE SUPPORT LH
Remove the 2 screws.
Disengage the 2 claws to remove the front bumper side support LH.
52115A
21.REMOVE FRONT BUMPER SIDE SUPPORT RH
Use the same procedure for the RH side and LH side.
86520
22.REMOVE LOW PITCHED HORN ASSEMBLY
86510
23.REMOVE HIGH PITCHED HORN ASSEMBLY
52611
24.REMOVE FRONT BUMPER ENERGY ABSORBER
Disengage the 4 guide to remove the front bumper energy absorber.
52021
25.REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Disengage the 5 clamps.
Remove the bolt.
Remove the 8 bolts and front bumper reinforcement sub-assembly.