1.INSTALL FRONT BUMPER ASSEMBLY
Engage the 2 claws as shown in the illustration.
Install the 3 clips.
Connect each connector.
Engage the 3 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the 4 clips.
Install the 4 screws and 2 bolts.
Install the screw.
Use the same procedure for the RH side and LH side.
Install the front bumper assembly with the 2 pin hold clips as shown in the illustration.
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.
Use the same procedure for the RH side and LH side.
53292A
2.INSTALL UPPER RADIATOR SUPPORT SEAL
Install the upper radiator support seal with the 8 clips.