53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 8 clips and upper radiator support seal.
2.REMOVE FRONT BUMPER ASSEMBLY
Apply protective tape around the front bumper assembly as shown in the illustration.
| *a | Protective Tape |
Using a screwdriver, turn each pin 90 degrees and remove the 2 pin hold clips as indicated by the arrows, in the order shown in the illustration.
| *1 | Pin Hold Clip |
| *a | 90° |
Use the same procedure for the RH side and LH side.
Remove the screw.
Use the same procedure for the RH side and LH side.
Remove the 2 bolts and 4 screws.
Using a clip remover, remove the 4 clips.
Disengage the 3 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Disconnect each connector.
Remove the 3 clips.
Disengage the 2 claws and remove the front bumper assembly as shown in the illustration.