Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
76926E
1.INSTALL FRONT SIDE MUDGUARD PROTECTOR
Install the 2 side panel retainers.
Install the front side mudguard protector with the 3 screws.
76923
2.INSTALL SIDE MUDGUARD RETAINER
Engage the clip.
Install the side mudguard retainer with the screw.
76908
3.INSTALL QUARTER PANEL MUDGUARD SUB-ASSEMBLY
When installing the quarter panel mudguard sub-assembly, heat the vehicle body and quarter panel mudguard sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Quarter Panel Mudguard Sub-assembly | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or quarter panel mudguard sub-assembly excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any remaining double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Using a heat light, heat the vehicle body and quarter panel mudguard sub-assembly.
Remove the release paper from the No. 7 side mudguard retainer
After removing the release paper, keep the exposed adhesive free from foreign matter.
Remove the application sheet from the No. 5 side mudguard retainer.
After removing the application sheet, keep the exposed adhesive free from foreign matter.
Engage the 2 clips and attach the double-sided tape.
| *a | Double-sided Tape |
Press the quarter panel mudguard sub-assembly firmly to install it.
Install the quarter panel mudguard sub-assembly with the 2 screws.
76932A
4.INSTALL NO. 1 SIDE MUDGUARD BRACKET
Engage the clip.
Install the No. 1 side mudguard bracket with the screw.
76906C
5.INSTALL SLIDE DOOR MUDGUARD SUB-ASSEMBLY
Engage the 8 clips as shown in the illustration.
Engage the 6 clips as shown in the illustration.
Install the screw.
Engage the 5 clips to install the slide door mudguard sub-assembly as shown in the illustration.
76904A
6.INSTALL FRONT DOOR MUDGUARD SUB-ASSEMBLY
When installing the front door mudguard sub-assembly, heat the vehicle body and front door mudguard sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Front Door Mudguard Sub-assembly | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or front door mudguard sub-assembly excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any remaining double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Using a heat light, heat the vehicle body and front door mudguard sub-assembly.
Remove the release paper from the 4 side mudguard pads.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Engage the 7 clips as shown in the illustration.
Engage the 5 clips and attach the double-sided tape as shown in the illustration.
| *a | Double-sided Tape |
Press the front door mudguard sub-assembly firmly to install it.
Install the nut.
Engage the 6 clips to install the front door mudguard sub-assembly as shown in the illustration.
76902B
7.INSTALL FENDER PANEL MUDGUARD SUB-ASSEMBLY
Engage the 3 clips as shown in the illustration.
Install the fender panel mudguard sub-assembly with the 2 screws and clip.