Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM U

SLIDING ROOF  SLIDING ROOF SYSTEM  TERMINALS OF ECU  


CHECK SLIDING ROOF DRIVE GEAR (REAR SUNSHADE CONTROL ECU)


U185953E03
3.51,0.469 3.813,0.656 0.302,0.188 10 false N2

a.

Disconnect the N2 ECU connector.


b.

Measure the voltage and resistance of the wire harness side connector.



Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
B (N2-1) - Body ground Y - Body ground Battery power supply Always 10 to 14 V
IG (N2-5) - Body ground R - Body ground IG power supply Ignition switch on (IG) 10 to 14 V
IG (N2-5) - Body ground R - Body ground IG power supply Ignition switch off Below 1 V
OPN (N2-7) - Body ground P - Body ground Sliding roof motor open signal Front sliding roof control switch is OPEN Below 1 Ω
OPN (N2-7) - Body ground P - Body ground Sliding roof motor open signal Front sliding roof control switch is OFF 10 kΩ or higher
CLS (N2-9) - Body ground V - Body ground Sliding roof motor close signal Front sliding roof control switch is CLOSE Below 1 Ω
CLS (N2-9) - Body ground V - Body ground Sliding roof motor close signal Front sliding roof control switch is OFF 10 kΩ or higher
UP (N2-10) - Body ground GR - Body ground Sliding roof motor open signal Rear sliding roof control switch is OPEN Below 1 Ω
UP (N2-10) - Body ground GR - Body ground sliding roof motor open signal Rear sliding roof control switch is OFF 10 kΩ or higher
DWN (N2-8) - Body ground BR - Body ground Sliding roof motor close signal Rear sliding roof control switch is CLOSE Below 1 Ω
DWN (N2-8) - Body ground BR - Body ground Sliding roof motor close signal Rear sliding roof control switch is OFF 10 kΩ or higher
E (N2-2) - Body ground W-B - Body ground Body ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.