Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM D

SLIDING ROOF  SLIDING ROOF SYSTEM  SYSTEM DESCRIPTION  


GENERAL


This system has the following functions: manual slide open and close; auto slide open and close; jam protection.


FUNCTION OF MAIN COMPONENT


Component Outline
Sliding roof drive gear (Rear sunshade control ECU) Sliding roof drive gear (rear sunshade control ECU) controls sliding roof motor to rotate forward and backward, which slides sliding roof sunshade trim
Power slide door control switch (Front sliding roof control switch)
Rear air conditioning panel (Rear sliding roof control switch)*1
Rear cooler switch (Rear sliding roof control switch)*2
Transmits a sliding roof ON / OFF signal to sliding roof drive gear (rear sunshade control ECU)

HINT:

*1: for Rear automatic air conditioning

*2: for Rear manual air conditioning



SYSTEM OPERATION


The sliding roof has the following features.

Function Outline
Manual slide open and close This function causes sliding roof to open (or close) when sliding roof control switch is pressed for a maximum of 0.3 seconds.
Sliding roof stops as soon as switch is released.
Auto slide open and close This function causes sliding roof to be fully opened (or closed) when sliding roof control switch is pressed for a minimum of 0.3 seconds
Protection function Jam protection function automatically stops sliding roof, or stops sliding roof and makes it open halfway (or fully tilts it upward) if a foreign matter gets jammed in sliding roof during auto close operation


MULTIPLEX COMMUNICATION SYSTEM (LIN) FUNCTION DESCRIPTION


LIN communication is used to control the ECUs connected to the main body ECU. If the communication line becomes unusable, the main body ECU outputs the related diagnostic codes, and the fail-safe function is used for maintaining minimum performance and preventing the malfunction from affecting the system.