Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM D

SLIDING ROOF  SLIDING ROOF SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle's Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.


CHECK DLC3


H103023E08
1.615,0.906 1.177,0.552 true 2.604,1.823 2.313,1.49 true 2.135,0.927 2.219,0.531 true 1.75,0.917 1.625,0.563 true 1.031,0.344 1.625,0.698 0.594,0.354 10 false CG 2.51,1.865 3.052,2.135 0.542,0.271 10 false BAT 1.51,0.344 2.104,0.698 0.594,0.354 10 false SG 2.135,0.354 2.729,0.708 0.594,0.354 10 false SIL

a.

The vehicle's ECM uses the ISO 14230 (M-OBD) communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-03 and matches the ISO 14230 format.

Symbols (Terminal No.) Terminal Description Condition Specified Condition
SIL (7) - SG (5) Bus "+" line During transmission Pulse generation
CG (4) - Body ground Chassis ground Always Below 1 Ω
SG (5) - Body ground Signal ground Always Below 1 Ω
BAT (16) - Body ground Battery positive Always 11 to 14 V

If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness or connector.

HINT:

Connect the cable of the intelligent tester to the DLC3, turn the ignition switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.

·
B135940E07
0.594,2.635 0.594,2.833 false 1.719,2.052 1.844,1.729 false 0.427,2.844 1.563,3.021 1.135,0.177 10 false Intelligent Tester 1.479,2.063 1.865,2.219 0.385,0.156 10 false DLC3


·

If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.

·

If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.