CHECK AUTO OPERATION
Turn the ignition switch on (IG).
When the sliding roof sunshade trim is fully closed, press the SLIDE OPEN switch for 0.3 seconds or more.
Check that the sliding roof sunshade trim automatically slides until it is fully opened.
When the sliding roof sunshade trim is fully open, press the SLIDE CLOSE switch for 0.3 seconds or more.
Check that the sliding roof sunshade trim automatically slides until it is fully closed.
When the auto operation is operating, check that pressing any sliding control switch or power window lock switch stops the sliding roof sunshade trim operation.
When pressing the switch for 0.3 seconds or less, the sliding roof sunshade trim moves but auto operation does not operate.
CHECK JAM PROTECTION FUNCTION
Do not use a part of your body, for example, your hand, to check the jam protection.
Do not allow anything to become caught in the sliding roof by accident in this procedure.
Perform the inspection from the inside of the vehicle.
Do not use hard objects such as a hammer, to avoid damage to the roof.
If the jam protection does not operate, reset the sliding roof drive gear (motor).
When the sliding roof close operation is operating and an object is caught between the vehicle body and sliding roof sunshade trim, check that the sliding roof sunshade trim opens a distance of 218 mm (8.58 in.) from the point of contact with the object, or opens fully if an opening distance of 218 mm (8.58 in.) is not available.