Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM U

SLIDING ROOF  SLIDING ROOF SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Read the Data List according to the display on the tester.

Sliding roof drive gear (Rear sunshade control ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Open Switch Slide switch open signal / ON or OFF ON: SLIDE OPEN switch is pressed
OFF: SLIDE OPEN switch is not pressed
-
Hall IC1 Status Sliding roof operating signal / NORMAL or LOCK NORMAL: Sliding roof motor is operating
LOCK: Sliding roof motor is not operating
-
Hall IC1 Pulse Sliding roof operating signal / LO or HI LO: Sliding roof motor is not operating
HI: Sliding roof motor is operating
-
Hall IC2 Status Sliding roof operating signal / NORMAL or LOCK NORMAL: Sliding roof motor is operating
LOCK: Sliding roof motor is not operating
-
Hall IC2 Pulse Sliding roof operating signal / LO or HI LO: Sliding roof motor is not operating
HI: Sliding roof motor is operating
-

Main body ECU
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Communication Slide Roof Communication status between sliding roof drive gear sub-assembly (sliding roof ECU) and main body ECU / OK or STOP OK: Connection
STOP: No connection
-



PERFORM ACTIVE TEST


HINT:

Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Perform the Active Test according to the display on the tester.

Sliding roof drive gear (Rear sunshade control ECU)
Tester Display Test Part Control Range
Slide Roof Operate sliding roof CLOSE
Close: Sliding roof CLOSE operation occurs
Off: Sliding roof is not operating
-
Slide Roof Operate sliding roof OPEN
Open: Sliding roof OPEN operation occurs
Off: Sliding roof is not operating
-