Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM D

SLIDING ROOF  SLIDING ROOF SYSTEM  INITIALIZATION  


RESET SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


NOTICE:
·

When disconnecting the sliding roof drive gear, the sliding roof drive gear requires initialization. If a reset is not executed, the following functions do not operate: auto operation and key off operation.

·

Use the front sliding roof control switch to perform the initialization.



a.

Turn the ignition switch on (IG).


b.

Erase the position memory.*


c.

Press and hold the CLOSE side of the front sliding roof control switch until the sliding roof sunshade trim is fully closed.


d.

After fully closing the sliding roof sunshade trim, continue pressing the CLOSE side of the front sliding roof control switch for 1 second or more.


e.

Check that the sliding roof stops at the fully closed position.


f.

Finish the initialization.


g.

Check that the AUTO operation works normally.

HINT:

*: The position memory can be erased using either of the following methods.

·

When the jam protection reverse operation occurs during the closing operation of the sliding roof sunshade, press and hold the CLOSE side of the front sliding roof control switch for 10 seconds or more.

·

When the sliding roof sunshade is in the fully closed position, press and hold the CLOSE side of the front sliding roof control switch for 10 seconds or more.