Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM J

SLIDING ROOF  SLIDING ROOF SYSTEM  Sliding Roof ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to the sliding roof drive gear (rear sunshade control ECU).

WIRING DIAGRAM

B143219E10
5.236,2.024 7.131,2.383 1.894,0.360 10 Sliding Roof Drive Gear (Rear Sunshade Control ECU) 5.964,0.353 6.262,0.518 0.298,0.165 10 IG 5.979,0.912 6.238,1.099 0.259,0.187 10 B 5.979,1.484 6.120,1.660 0.141,0.177 10 E 4.3,0.781 4.858,0.933 0.559,0.152 10 S/R 1.99,0.907 2.766,1.077 0.776,0.170 10 from Battery 1.365,0.363 2.889,0.556 1.524,0.192 10 from RH ECU-IG Fuse 5.252,1.87 5.480,2.016 0.229,0.145 10 N2 5.735,1.597 5.898,1.756 0.163,0.159 10 2 5.735,0.469 5.877,0.614 0.142,0.145 10 5 5.735,1.033 5.860,1.178 0.125,0.145 10 1

PROCEDURE

1.INSPECT FUSE (S/R)
a.

Remove the S/R fuse from the main body ECU.


b.

Measure the resistance of the fuse.

Standard resistance:

Below 1 Ω




OK

2.CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND)
a.

Disconnect the N2 drive gear connector.


b.

Measure the voltage of the wire harness side connector.

Standard voltage:
Tester Connection Switch Condition Specified Condition
N2-5 (IG) - Body ground Engine switch on (IG) 10 to 14 V
N2-5 (IG) - Body ground Engine switch off Below 1 V
N2-1 (B) - Body ground Always 10 to 14 V



c.

Measure the resistance of the wire harness side connector.

Standard resistance:
Tester Connection Specified Condition
N2-2 (E) - Body ground Below 1 Ω




OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR