63282B
1.REMOVE TILT ROOF LOCK STRIKER
Remove the 3 bolts and tilt roof lock striker.
63619
2.REMOVE TILT ROOF PANEL COVER
Remove the 2 covers.
63215G
3.REMOVE MOON ROOF FRONT MOULDING
Remove the moulding.
63306
4.REMOVE SUNSHADE TRIM SUB-ASSEMBLY (for Front Side)
Using a T20 "TORX" driver, remove the 2 screws and tilt roof sunshade guide rear RH.
Use the procedure above for the LH side.
Slide and remove the sunshade trim sub-assembly.
63303
5.REMOVE NO. 2 SUNSHADE TRIM SUB-ASSEMBLY (for Front Side)
Using a T20 "TORX" driver, remove the 2 screws and tilt roof sunshade guide front RH.
Use the procedure above for the LH side.
Slide and remove the sunshade trim as shown in the illustration.
63260A
6.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (for Rear Side)
Remove the 2 bolts and drive gear.
63303
7.REMOVE NO. 2 SUNSHADE TRIM SUB-ASSEMBLY (for Rear Side)
Using a T20 "TORX" driver, remove the 2 screws and sliding roof sunshade guide rear RH.
Use the procedure above for the LH side.
Using a T20 "TORX" driver, remove the 2 screws and sliding roof sunshade guide front RH.
Use the procedure above for the LH side.
Slide the No. 2 sunshade trim to the cutouts of the sliding roof housing shown in the illustration and disengage each guide A from the left and right sides.
Slide the tips of the sunshade trim rails to the cutouts of the sliding roof housing shown in the illustration.
Slide the No. 2 sunshade trim toward the front of the vehicle, disengage each guide B from the left and right sides and remove the No. 2 sunshade trim.
63306
8.REMOVE SUNSHADE TRIM SUB-ASSEMBLY
Slide the sunshade trim in the direction of the arrow shown in the illustration.
Disconnect the sliding roof drive cable from the sunshade trim and remove the sunshade trim.
Do not bend or twist the sliding roof drive cable as it will damage the cable.