BRIEF DESCRIPTION
The CAN (Controller Area Network) is a serial data communication system for real time application. It is a vehicle multiplex communication system which has a high communication speed (500 kbps, 250 kbps) and the ability to detect malfunctions.
By pairing the CANH and CANL bus lines, the CAN performs communication based on differential voltages.
Many ECUs (sensors) installed on the vehicle operate by sharing information and communicating with each other.
The CAN has 2 resistors of 120 Ω which are necessary to communicate with the main wire.
DEFINITION OF TERMS
Main wire
The main wire is a wire harness between the 2 termination circuits on the bus (communication line). This is the main bus in the CAN communication system.
Branch wire
The branch wire is a wire harness which diverges from the main wire to an ECU or sensor.
Termination circuits
The termination circuits is a circuit which converts the communication current of the CAN communication into the bus voltage. It consists of a resistor. 2 termination circuits are necessary on a bus.
CAN J/C
The CAN J/C is designed so that it can be used with CAN communication which has a termination circuit and CAN communication which does not have a termination circuit.
CIRCUIT DESCRIPTION
For vehicles with the AFS system: The CAN communication system consists of the CAN No. 1 bus, CAN No. 2 bus and MS bus, which are connected to each system through the network gateway ECU (for RHD).
For vehicles with the power side door, power back door or smart entry and start system: The CAN communication system consists of the CAN No. 1 bus, CAN No. 2 bus and MS bus, which are connected to each system through the main bus ECU.
The CAN No. 1 bus, CAN No. 2 bus and MS bus each have termination circuits with 2 resistors of 120 Ω. High speed communication at 500 kbps and 250 kbps is possible.
ECU OR SENSOR WHICH COMMUNICATE VIA CAN COMMUNICATION SYSTEM
Brake actuator (Skid control ECU)*1
ABS and traction actuator (Skid control ECU)*2
Power steering ECU
Steering angle sensor*3
Yaw rate sensor*2
ECM
Center airbag sensor
Air conditioning amplifier
Combination meter ECU
Main body ECU
Network gateway ECU (for RHD)
AFS ECU*4
Navigation receiver assembly*5
Power slide door ECU LH*6
Power slide door ECU RH*6
Power back door ECU*7
Certification ECU
*1: w/o VSC
*2: w/ VSC
*3: w/ VSC or w/ AFS
*4: w/ AFS
*5: w/ Navigation system
*6: w/ Power slide door system
*7: w/ Power back door system
DIAGNOSTIC CODES FOR CAN COMMUNICATION SYSTEM
DTCs for the CAN communication system are as follows: U0073, U0100, U0101, U0121, U0123, U0126, U0129, U0140, U0155, U0182, U1002, B1207, B1216, B1217, B1287, B1499, B2326 and B2427.
NOTES REGARDING TROUBLESHOOTING
A malfunction in the CAN bus (communication line) can be checked through the DLC3 (except when there is a wire break in the branch wire of the DLC3).
Do not connect the tester directly to the DLC3 connector. Be sure to use a service wire.
DTCs regarding the CAN communication system can be checked using the intelligent tester.
The CAN communication system cannot detect a malfunction in the branch line of the DLC3 even though the DLC3 is also connected to the CAN communication system.