| Detection Item | Symptom | Trouble Area |
|---|---|---|
| POWER STEERING ECU COMMUNICATION STOP MODE | When either condition below is met:
·
EPS is not displayed on "Communication Bus Check" screen of intelligent tester ·
Applies to "POWER STEERING ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE" |
·
Power source or inside power steering ECU ·
Power steering ECU branch wire and connector ·
Power steering ECU |
Turn the engine switch off before measuring the resistances of the main wire and the branch wire.
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the G91 power steering ECU connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G91-1 (CANH) - G91-7 (CANL) | Engine switch off | 54 to 69 Ω |
OK
NG
Disconnect the A21 and G91 power steering ECU connectors.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
|---|---|
| A21-2 (PGND) - Body ground | Below 1 Ω |
Measure the voltage of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A21-1 (PIG) - Body ground | Always | 11 to 14 V |
| G91-6 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
OK
NG