| Detection Item | Symptom | Trouble Area |
|---|---|---|
| CENTER AIRBAG SENSOR COMMUNICATION STOP MODE | When either condition below is met:
·
SRS Airbag is not displayed on "BUS CHECK" screen of intelligent tester ·
Applies to "CENTER AIRBAG SENSOR COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE" |
·
Power source or inside center airbag sensor assembly ·
Center airbag sensor assembly branch wire and connector ·
Center airbag sensor assembly |
Turn the engine switch off before measuring the resistances of the main wire and the branch wire.
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the G19 center airbag sensor connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G19-13 (CANH) - G19-22 (CANL) | Engine switch off | 54 to 69 Ω |
OK
NG
Disconnect the G19 center airbag sensor connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
|---|---|
| G19-25 (E1) - Body ground | Below 1 Ω |
| G19-26 (E2) - Body ground | Below 1 Ω |
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G19-21 (IG2) - Body ground | Engine switch on (IG) | 11 to 14 V |
OK
NG