Home › Power Source / Network › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM › from 2016.05
RM24M0E _57 Power Source / Network _059598 CAN COMMUNICATION _0292257 CAN COMMUNICATION SYSTEM J

CAN COMMUNICATION  CAN COMMUNICATION SYSTEM  Open in One Side of CAN Branch Line  


DESCRIPTION

If 2 or more ECUs and/or sensors do not appear on the intelligent tester's "Communication Bus Check" screen, one side of the CAN branch wire may be open. (One side of the CANH [branch wire] /CANL [branch wire] of the ECU and/or sensor is open.)

Symptom Trouble Area
2 or more ECUs and/or sensors do not appear on intelligent tester "Communication Bus Check" screen. One side of CAN branch wire is open
·

ABS and traction actuator (skid control ECU)

·

Power steering ECU

·

Steering angle sensor

·

Yaw rate sensor

·

Center airbag sensor assembly

·

Air conditioning amplifier

·

Main body ECU

·

AFS ECU*1

·

Clearance warning ECU assembly*2

·

Navigation receiver assembly*3



·

*1: w/ AFS

·

*2: w/ Toyota Parking Assist-sensor System

·

*3: w/ Navigation System


CAUTION / NOTICE / HINT

NOTICE:

Turn the engine switch off before measuring the resistances of the main wire and the branch wire.


HINT:
·

Perform the following inspection for the ECUs (sensors) which are not displayed on the intelligent tester. If a malfunction cannot be identified, perform the following inspections for the ECUs (sensors) connected to the CAN communication system.

·

Do not remove the combination meter assembly (combination meter ECU) and ECM, as they are the end parts of the circuit. If removed, CAN communication will not be possible.

·

The open circuit confirmation of the combination meter assembly (combination meter ECU), ECM and main wire is performed in the CHECK CAN BUS LINE procedure of HOW TO PROCEED WITH TROUBLESHOOTING. This inspection only has procedures for checking for an open circuit on one side of the CAN branch wire.



PROCEDURE

1.CHECK FOR OPEN IN ONE SIDE OF BRANCH WIRE
a.

Based on the vehicle equipment and specifications, confirm the systems that use CAN communication (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).


b.

Select "BUS CHECK" on the intelligent tester (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).


c.

Observe the screen for approximately 2 minutes to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.


d.

Check the applicable communication stop mode for the ECU or sensor that is not displayed on the screen.



NEXT