| Detection Item | Symptom | Trouble Area |
|---|---|---|
| AIR CONDITIONING AMPLIFIER COMMUNICATION STOP MODE | When either condition below is met:
·
Air Conditioner is not displayed on "BUS CHECK" screen of intelligent tester ·
Applies to "AIR CONDITIONING AMPLIFIER COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE" |
·
Power source or inside air conditioning amplifier ·
Air conditioning amplifier branch wire and connector ·
Air conditioning amplifier |
Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the G47 air conditioning amplifier connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G47-11 (CANH) - G47-12 (CANL) | Ignition switch off | 54 to 69 Ω |
OK
NG
Disconnect the G47 air conditioning amplifier connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
|---|---|
| G47-14 (GND) - Body ground | Below 1 Ω |
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G47-21 (B) - Body ground | Always | 10 to 14 V |
| G47-1 (IG+) - Body ground | Ignition switch on (IG) | 10 to 14 V |
OK
NG