| Detection Item | Symptom | Trouble Area |
|---|---|---|
| MAIN BODY ECU COMMUNICATION STOP MODE | When either condition below is met:
·
Main Body is not displayed on "BUS CHECK" screen of intelligent tester ·
Applies to "MAIN BODY ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE" |
·
Power source or inside main body ECU ·
Main body ECU branch wire and connector ·
Main body ECU |
Turn the engine switch off before measuring the resistances of the main wire and the branch wire.
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the G59 main body ECU connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G59-5 (CANH) - G59-6 (CANL) | Engine switch off | 54 to 69 Ω |
| G59-16 (CANP) - G59-15 (CANN) | Engine switch off | 108 to 132Ω |
OK
NG
Disconnect the G59 main body ECU connector.
Disconnect the 4A and 4K junction block connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G59-1 (GND1) - Body ground | Below 1 Ω |
| 4A-3 (GND2) - Body ground | Below 1 Ω |
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
|---|---|
| 4K-1 (BECU) - Body ground | 10 to 14 V |
OK
NG