REMOVAL
Removal / installation · Vehicles built Jul 2007 – Oct 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE FRONT DOOR SCUFF PLATE LH |
 |
Disengage the 14 claws and remove the front door scuff plate.
| 3.
REMOVE FRONT FLOOR FOOTREST
|
 |
- Disengage the 4 claws and remove the front floor footrest.
| 4.
REMOVE FOOTREST CLIP
|
 |
- Remove the 2 footrest clips.
| 5.
REMOVE COWL SIDE TRIM BOARD LH |
 |
Remove the clip.
Disengage the 2 claws and remove the cowl side trim board.
| 6.
REMOVE INSTRUMENT PANEL GARNISH LH
|
 |
- Remove screw <H>.
Disengage the 3 clips and remove the instrument panel garnish.
- NOTICE:
- Pull the instrument panel garnish up at an angle of 45° to remove it.
- Do not damage the surface of the instrument panel when removing it.
| 7.
REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
- Disengage the 4 clips and 2 claws and remove the instrument panel register.
- NOTICE:
- To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
- Pull the instrument panel register up diagonally to remove it.
| 8.
REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
|
 |
- Disengage the 3 claws and separate the hood lock control lever.
| 9.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
|
 |
- Remove the 2 <F> bolts.
Disengage the 5 clips and claw and remove the lower instrument panel finish panel.
| 10.
REMOVE INSTRUMENT CLUSTER FINISH PANEL
|
 |
- Disengage the 3 clips and the 4 claws and remove the instrument cluster finish panel.
Disconnect the connectors.
| 11.
REMOVE COMBINATION METER ASSEMBLY |
 |
- Remove the 4 screws.
- Disconnect the 2 connectors and clamp and remove the combination meter.