2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012


DATA LIST
By reading the Data List displayed on the intelligent tester, you can check values, including those of the switches, sensors, actuators without removing any parts. Reading the Data List as the first step of troubleshooting is one method of shortening diagnostic time.
  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to ON.

  5. Operate the intelligent tester according to the display on the tester screen and select Data List.

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed:
    Min.: 0 rpm
    Max.: 16383.75 rpm
    650 to 750 rpm: Idling
    -
    Coolant Temp
    Engine coolant temperature:
    Min.: -40°C
    Max.: 140°C
    80° to 100°C (176°F to 212°F)
    After warming up
    1. If value is -40°C (-40°F): sensor circuit open
    2. If value is 140°C (284°F): sensor circuit shorted
    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Maximum wheel speed sensor reading:
    Min.: 0 km/h (0 mph)
    Max.: 326 km/h (202 mph)
    Actual vehicle speed
    Speed indicated on speedometer

← FAIL-SAFE CHART (from Aug 2012)DATA LIST / ACTIVE TEST (Aug 2009 – Oct 2010) →