2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built Aug 2012 – Oct 2012

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012


DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Combination Meter / Data List.

  5. According to the display on the intelligent tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Tail Relay SW
    Taillight relay/
    ON or OFF
    ON: Headlight dimmer switch (Light control switch) → TAIL
    OFF: Headlight dimmer switch (Light control switch) → OFF
    -
    ODO/TRIP Change SW
    ODO/TRIP switch/
    ON or OFF
    ON: ODO/TRIP switch pushed
    OFF: ODO/TRIP switch not pushed
    -
    P-Seatbelt Buckle SW
    Buckle switch (Front passenger side)/
    ON or OFF
    ON: Front passenger side seat belt is fastened
    OFF: Front passenger side seat belt is unfastened
    -
    Vehicle Speed Meter
    Vehicle speed/
    Min.: 0, Max.: 255
    Approximately same as actual vehicle speed (When vehicle is being driven)
    Unit: km/h
    Engine Rpm
    Engine speed/
    Min.: 0, Max.: 12750
    Approximately same as actual engine speed (when engine is running)
    Unit: rpm
    Coolant Temperature
    Engine coolant temperature/
    Min.: 0 (32), Max.: 127.5 (261.5)
    After warming up:
    75 to 105 (167 to 221)
    Unit: °C (°F)
    Reverse Range Switch (6MT)*1
    Reverse range switch/
    ON or OFF
    ON: Reverse range switch ON
    OFF: Reverse range switch OFF
    -
    +B Voltage Value
    Battery voltage/
    Min.: 0, Max.: 25.5
    Between 1 V and 14 V
    Unit: V
    Fuel Input
    Fuel input signal/
    Min.: 0, Max.: 127.5
    Fuel sender input value
    Unit: Liters
    Rheostat value
    Light control rheostat switch input/
    Min.: 0, Max.: 100
    Light control rheostat switch Dark (0 %) → Bright (100 %)
    Unit: %
    Driver Side Seatbelt Warning Buzzer
    Driver side seat belt warning buzzer/
    ON or OFF
    ON: Driver side seat belt warning buzzer ON
    OFF: Driver side seat belt warning buzzer OFF
    -
    P-Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer/
    ON or OFF
    ON: Front passenger side seat belt warning buzzer ON
    OFF: Front passenger side seat belt warning buzzer OFF
    -
    Number of Trouble Code
    Number of trouble codes/
    MIN.: 0, MAX.: 255
    Number of DTCs will be displayed
    -
    1. *1: for Manual Transmission


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Combination Meter / Active Test.

  5. According to the display on the intelligent tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    OFF/0/40/80/120/160/200 km/h
    Perform the test with the vehicle stopped and the engine idling.
    TachoMeter Operation
    Tachometer
    OFF/0/1000/2000/3000/4000/5000/6000/7000 rpm
    Perform the test with the vehicle stopped and the engine idling.
    Fuel Meter Operation
    Fuel receiver gauge
    OFF/Empty/ 1/2 /Full
    Perform the test with the vehicle stopped and the engine idling.
    Volt Meter Operation
    Voltmeter
    OFF, 0, 3, 6, 9, 12, 15 or 18 V
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Lamp Airbag
    Airbag warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Lamp ABS
    ABS warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Lamp Slip
    Slip indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Lamp Fuel
    Fuel warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    ACTIVE TRC Indicator*1
    ACTIVE TRC indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    VSC TRC Indicator
    VSC TRC indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    A/T Oil Temperature Operation*2
    A/T oil temperature warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Lamp Cruise*3
    CRUISE indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Lamp Brake
    Brake warning light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. Over Speed*4
    Speed limit indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. CRAWL*5
    CRAWL indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Indicat. VSC OFF
    VSC OFF indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    OFF, LOW, NORMAL or HIGH
    Perform the test with the vehicle stopped and the engine idling.
    Meter Display 1
    Meter display
    OFF/6/5/4/3/2/1/0/All
    Perform the test with the vehicle stopped and the engine idling.
    Meter Display 2
    Meter display
    OFF/9/8/7
    Perform the test with the vehicle stopped and the engine idling.
    1. *1: w/ Active Traction Control
    2. *2: for Automatic Transmission
    3. *3: w/ Cruise Control System
    4. *4: w/ Speed Warning Function
    5. *5: w/ CRAWL

← DATA LIST / ACTIVE TEST (Nov 2010 – Jul 2012)DATA LIST / ACTIVE TEST (from Nov 2012) →