2011-2016 FJ Cruiser · Service Manual ENGINE

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Jul 2007

HINT:
Intelligent tester only:
Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.

NOTICE:
All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or OFF while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.


CHECK MODE PROCEDURE (Using intelligent tester)
  1. Check and ensure the following conditions:

    1. Battery positive voltage 11 V or more.

    2. Throttle valve fully closed.

    3. Transmission in the neutral position.

    4. A/C switch OFF.

  2. Turn the ignition switch OFF.

  3. Connect an intelligent tester to the DLC3.

  4. Turn the ignition switch ON.

  5. Turn the tester ON.

  6. Select the following menu items: Utility / Check Mode.

  7. Switch the ECM from normal mode to check mode.

  8. A076900E04
    Make sure that the MIL flashes as shown in the illustration.

  9. Start the engine.

  10. Make sure that the MIL turns off.

  11. Simulate the conditions of the malfunction described by the customer.

  12. Check for DTCs and freeze frame data using the tester.

← FREEZE FRAME DATA (from Aug 2014)FAIL-SAFE CHART (Jul 2007 – Nov 2007) →