2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


DESCRIPTION
The ECU controls the cruise control system of the vehicle. The data and DTCs relating to the cruise control system can be read from the DLC3 of the vehicle. If any DTC is not displayed when checking for DTCs, there may be a problem with either the combination meter or the CAN communication system. Use a intelligent tester to check and solve the problem.

CHECK DLC3
  1. Check the DLC3 (Click here).


CHECK INDICATOR

  1. B133353E01
    Turn the ignition switch to the ON position.

  2. Check that the CRUISE MAIN indicator light comes on when the cruise control main switch ON-OFF button is pushed on, and that the indicator light goes off when the ON-OFF button is pushed off.

    HINT:
    BE04034E22
    If there is a problem with the ON/OFF illumination of the indicator light, inspect the cruise main indicator light circuit (Click here).

    HINT:
    If a malfunction occurs in the vehicle speed sensor, stop light switch assembly or other related parts during cruise control driving, the ECM actuates AUTO CANCEL of the cruise control. Then the CRUISE MAIN indicator light starts to blink, to inform the driver of the malfunction. At the same time, data of the malfunction is stored as a diagnostic trouble code (DTC).

← TERMINALS OF ECM (from Nov 2010)DIAGNOSIS SYSTEM (from Nov 2010) →