2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

TERMINALS OF ECM

System information · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010


CHECK ECM
A227797E01
  1. Disconnect the B49, E81 and E82 ECM connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E82-24 (BATT) - Body ground
    L - Body ground
    Power source
    Always
    11 to 14 V
    E82-8 (ST1-) - Body ground
    R-L - Body ground
    Stop light switch signal circuit
    Ignition switch ON, brake pedal released
    11 to 14 V
    Ignition switch ON, brake pedal depressed
    Below 1 V
    E81-18 (STP) - Body ground
    G-Y - Body ground
    Stop light switch signal circuit
    Brake pedal depressed
    11 to 14 V
    Brake pedal released
    Below 1 V
    E81-11 (CCS) - Body ground
    L-B - Body ground
    Cruise control switch circuit
    Cruise control switch on
    Below 2.5 Ω
    Cruise control switch off
    1 MΩ or higher
    +RES switch held on
    235 to 245 Ω
    -SET switch held on
    617 to 643 Ω
    CANCEL switch held on
    1509 to 1571 Ω
    B49-12 (E1) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the ECM connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    B47-27 (D) - Body ground*1
    V - Body ground
    Park/neutral position switch signal
    Ignition switch ON, shift lever D or 4 positions
    11 to 14 V
    Ignition switch ON, shift lever other than D and 4 positions
    Below 1 V
    B47-27 (D) - Body ground*2
    L-B - Body ground
    Clutch switch input signal
    Ignition switch ON, depress clutch pedal
    Below 1 V
    Ignition switch ON, release clutch pedal
    11 to 14 V
    1. *1: for Automatic Transmission
    2. *2: for Manual Transmission
    If the result is not as specified, the ECM may be malfunctioning.

← TERMINALS OF ECM (Aug 2009 – Oct 2010)DIAGNOSIS SYSTEM (Jul 2007 – Oct 2010) →