2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2009 – Jul 2013

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014


1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the service hole cover from the engine under cover.

  1. A070279E02
    Install a vinyl hose onto the drain on the radiator side.
    Text in Illustration 
    *1
    Vinyl Hose
    *2
    Tape

  1. Fix the vinyl hose with tape.

    A220213E01

    Text in Illustration 
    *1
    Radiator Cap
    *2
    Reservoir Cap
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Drain Cock Plug

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap and drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the 2 cylinder block drain cock plugs and drain the coolant from the engine.

    NOTICE:
    If coolant is not drained from the radiator drain cock plug, cylinder block drain cock plugs and radiator reservoir, clogging in the radiator or coolant leakage from the seal of water pump may result.


2. REMOVE V-BANK COVER

  1. A221454E02
    Raise the front of the V-bank cover to disengage the 2 pins.

  1. Remove the 2 V-bank cover hooks from the bracket.

  1. Remove the V-bank cover.

    Text in Illustration 
    *1
    Pin
    *2
    Hook


3. REMOVE AIR CLEANER HOSE ASSEMBLY

  1. A226624
    Disconnect the ventilation hose and vacuum hose.

  1. Disengage the wire harness clamp.

  1. Remove the bolt.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose assembly.


4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

  1. A226610
    Disconnect the No. 5 water by-pass hose.

  1. Disconnect the No. 4 water by-pass hose.

  1. A226611
    Disconnect the throttle body connector.

  1. Remove the 4 bolts.

  1. Remove the throttle with motor body assembly and gasket.

← REMOVAL (Jul 2007 – Jul 2009)REMOVAL (Aug 2013 – Jul 2014) →