2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014


1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the service hole cover from the engine under cover.

  1. A070279E03
    Install a vinyl hose to the radiator drain cock on the radiator assembly side.
    Text in Illustration 
    *a
    Vinyl Hose
    *b
    Tape

  1. Fix the vinyl hose with tape.

    A307922E01

    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Reserve Tank Cap Sub-assembly
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Drain Cock Plug

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly and drain the engine coolant.

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the cylinder block drain cock plug and drain the engine coolant from the engine.

    NOTICE:
    If engine coolant is not drained from the radiator drain cock plug, cylinder block drain cock plug and radiator reservoir, clogging in the radiator assembly or engine coolant leakage from the seal of water pump may result.


2. REMOVE V-BANK COVER

  1. A221454E02
    Raise the front of the V-bank cover to disengage the 2 pins.

  1. Remove the 2 V-bank cover hooks from the bracket.

  1. Remove the V-bank cover.

    Text in Illustration 
    *1
    Pin
    *2
    Hook


3. REMOVE AIR CLEANER HOSE ASSEMBLY

  1. A226624
    Disconnect the ventilation hose and vacuum hose.

  1. Disengage the wire harness clamp.

  1. Remove the bolt.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose assembly.


4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

  1. A226610
    Disconnect the No. 5 water by-pass hose.

  1. Disconnect the No. 4 water by-pass hose.

  1. A226611
    Disconnect the throttle body connector.

  1. Remove the 4 bolts.

  1. Remove the throttle with motor body assembly and gasket.

← REMOVAL (Aug 2009 – Jul 2013)REMOVAL (from Aug 2014) →