2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

  1. A126439
    Install the accelerator pedal rod assembly with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    NOTICE:
    1. Avoid any physical impact to the accelerator pedal assembly.
    2. Do not disassemble the accelerator pedal assembly.
    3. This accelerator pedal rod assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal rod assembly. If applied, the accelerator pedal rod assembly must be replaced.

  1. Connect the accelerator pedal rod assembly connector.


2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← REMOVAL (from Jul 2007)COMPONENTS (Jul 2007 – Jul 2009) →