2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014


CHECK FUEL PUMP
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON.

    NOTICE:
    Do not start the engine.

  1. Turn the intelligent tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pump Speed Control.

  1. Check the fuel operation by operating it with the intelligent tester.
    If the fuel pump does not operate, replace the fuel pump.


CHECK FUEL PRESSURE
  1. Discharge the fuel pressure system (Click here).

  1. Using a voltmeter, measure the battery voltage.

    Standard voltage:
    11 to 14 V

  1. Disconnect the negative battery terminal.

  1. Disengage the fuel pipe clamp.

  1. Disconnect the fuel pipe No. 1.

  1. A065093E02
    Install SST and the fuel tube connector onto the vehicle.

  1. Wipe off any spilt gasoline.

  1. Connect the cable to the negative battery terminal.

    Torque:
    3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the intelligent tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pump Speed Control / ON.

  1. Measure the fuel pressure.

    Standard:
    281 to 287 kPa (2.87 to 2.93 kgf/cm2, 40.8 to 41.7 psi)

    1. If the fuel pressure is greater than the standard value, replace the fuel pump.
    1. If the fuel pressure is less than the standard value, check the connection between the fuel hose and fuel pump.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pump Speed Control / OFF.

  1. Check that the fuel pressure does not change for 5 minutes.

    Standard:
    147 kPa (1.5 kgf/cm2, 21 psi)

    If the result is not as specified, check the fuel pump and fuel injector.

  1. Disconnect the intelligent tester from the DLC3.

  1. Disconnect the cable from the battery negative terminal.

  1. Remove SST and the fuel tube connector while being careful to prevent gasoline splashes.

  1. Connect the fuel tube.


CHECK FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON.

    NOTICE:
    Do not start the engine.

  1. Turn the Techstream ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pump Speed Control / ON.

  1. Check that there is no leakage from the fuel system.

← SYSTEM DIAGRAM (from Aug 2014)ON-VEHICLE INSPECTION (Aug 2009 – Oct 2012) →