2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
  1. Check the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON.

    3. Turn the tester ON.

    4. Start the engine and warm it up.

    5. Select the following menu items: Powertrain / Engine and ECT / Data List / Accelerator Position No. 1, Accelerator Position No. 2.

    6. Operate the accelerator pedal, then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.

      Standard voltage:
      ACCELERATOR POSITION NO. 1:
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Fully depressed
      2.6 to 4.5 V
      ACCELERATOR POSITION NO. 2:
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Fully depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal rod assembly, wire harness and ECM.

← COMPONENTS (from Jul 2007)REMOVAL (from Jul 2007) →