2011-2016 FJ Cruiser · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. INSTALL YAW RATE AND DECELERATION SENSOR (for Automatic Transmission)
  1. Engage the clamp to the hole of the sensor bracket.

  1. Install the yaw rate and deceleration sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Make sure that the sensor is at the correct angle when installing.

  1. Connect the yaw rate and deceleration sensor connector.


2. INSTALL YAW RATE AND DECELERATION SENSOR (for Manual Transmission)
  1. Install the yaw rate and deceleration sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Make sure that the sensor is at the correct angle when installing.

  1. Connect the yaw rate and deceleration sensor connector.


3. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
  1. Engage the 3 guides and 5 clips and install the console upper rear panel.


4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)

  1. B133896
    Install the shift lever knob.


5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

  1. B133894
    Install the shift lever knob.


6. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY

  1. B271483
    Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 guides.

  1. Engage the 4 claws and install the parking brake hole cover.


7. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)

8. CHECK VSC SENSOR SIGNAL
(Click here)
← INSTALLATION (Jul 2007 – Oct 2010)INSTALLATION (from Aug 2012) →