2011-2016 FJ Cruiser · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. INSTALL YAW RATE AND DECELERATION SENSOR

C133072E01
  1. Install the yaw rate and deceleration sensor with the 2 bolts.

    Torque:
    13 N*m{ 136 kgf*cm , 10 ft.*lbf }

    NOTICE:
    Make sure that the sensor is at the correct angle when installing.

  1. Connect the yaw rate and deceleration sensor connector.


2. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

  1. B133897
    Engage the 3 claws and 5 clips and install the console upper rear panel.


3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

  1. B133896
    Install the shift lever knob.


4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

  1. B133894
    Install the shift lever knob.


5. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY

B133901E01
  1. Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 C claws.

  1. Engage the 4 claws and install the parking brake hole cover.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


7. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)

8. CHECK VSC SENSOR SIGNAL
(Click here)
← INSPECTION (from Jul 2007)INSTALLATION (Nov 2010 – Jul 2012) →