2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2007

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. REMOVE ACCESS PANEL REAR WEATHERSTRIP

HINT:
Use the same procedure as for the RH side (Click here).


2. REMOVE LAP BELT OUTER ANCHOR COVER

HINT:
Use the same procedure as for the RH side (Click here).


3. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side (Click here).


4. REMOVE NO. 1 CUP HOLDER

HINT:
Use the same procedure as for the RH side (Click here).


5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side (Click here).


6. REMOVE CENTER PILLAR UPPER GARNISH

HINT:
Use the same procedure as for the RH side (Click here).


7. REMOVE REAR DOOR OPENING TRIM

HINT:
Use the same procedure as for the RH side (Click here).


8. REMOVE ACCESS DOOR GLASS OUTER WEATHERSTRIP

HINT:
Use the same procedure as for the RH side (Click here).


9. REMOVE REAR DOOR GLASS

B139400E01
  1. Apply protective tape to the outer circumference of the rear door glass, as shown in the illustration.

  1. From the interior, insert piano wires between the vehicle body and rear door glass, as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the rear door glass from the vehicle, do not damage the vehicle's paintwork or exterior/interior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the rear door glass.

← COMPONENTS (from Jul 2007)INSTALLATION (from Jul 2007) →