2011-2016 FJ Cruiser · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

HINT:
  1. Use the same procedure for both RH and LH sides.
  2. The procedure described below is for the RH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ACCESS PANEL REAR WEATHERSTRIP

B135524
  1. Remove the access panel rear weatherstrip.


3. REMOVE LAP BELT OUTER ANCHOR COVER

B135525
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.


4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

B135527
  1. Insert a clip remover between the handle and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door inside handle and snap ring.


5. REMOVE NO. 1 CUP HOLDER

B135528
  1. Remove the screw and the No. 1 cup holder.


6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

B135526
  1. Remove the bolt and separate the front seat belt outer (floor side).

  1. B135558
    Disengage the 9 clips and remove the rear door trim panel.


7. REMOVE NO. 1 DOOR TRIM BRACKET

B135529
  1. Remove the 2 screws and remove the No. 1 door trim bracket.


8. REMOVE CENTER PILLAR UPPER GARNISH

B135559
  1. Remove the clip.

  1. Remove the 2 screws.

  1. B135560
    Disengage the 2 clips and remove the center pillar upper garnish.


9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. B135087
    Remove the nut and the through anchor.

  1. B135089E01
    for RH Side:

    1. Using a screwdriver, release the locking button of the pretensioner connector.

    2. Using a screwdriver, disconnect the pretensioner connector.

    3. B135088
      Remove the 2 bolts, the 2 hooks and the retractor.

  1. B135092
    for LH Side:

    1. Disconnect the tension reducer connector.

    2. Remove the 2 bolts, the 2 hooks and the retractor.

    3. B135093E01
      Using a screwdriver, release the locking button of the pretensioner connector.

    4. Using a screwdriver, disconnect the pretensioner connector.


10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

  1. B135095
    Remove the 2 bolts, the hook and the shoulder belt anchor adjuster.


11. REMOVE ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY

B135530
  1. Disconnect the rod.

  1. Remove the 3 bolts, then remove the access panel inside handle.


12. REMOVE ACCESS PANEL UPPER LOCK ASSEMBLY

B135531
  1. Disconnect the connector, harness clamp and the access panel lock control cable.

  1. B135532
    Remove the 3 bolts, then remove the access panel upper lock.


13. REMOVE ACCESS PANEL LOWER LOCK ASSEMBLY

B135561
  1. Disconnect the connector, connector clamp and access panel lock control cable.

  1. B135562
    Using "Torx" socket wrench T30, remove the 3 screws.

  1. Remove the access panel lower lock by sliding it upward.


14. REMOVE ACCESS PANEL LOCK REMOTE CONTROL ASSEMBLY

B135533
  1. Disconnect the rod and connector clamp.

  1. Remove the 2 bolts, then remove the access panel lock remote control.


15. REMOVE ACCESS PANEL LOCK CANCEL LEVER ASSEMBLY

B135534
  1. Using "Torx" socket wrench T30, remove the 2 screws and remove the access panel lock cancel lever.


16. REMOVE FRONT DOOR COURTESY SWITCH

E127226
  1. Remove the bolt and front door courtesy switch.

  1. Disconnect the connector.


17. REMOVE ACCESS PANEL LOCK STRIKER PLATE ASSEMBLY

B135535
  1. Using "Torx" socket wrench T40, remove the 2 screws and access panel lock striker plate.


18. REMOVE REAR DOOR PANEL PROTECTOR (w/ Door Panel Protector)

  1. B356580
    Remove the rear door panel protector.


19. REMOVE REAR DOOR OPENING TRIM

  1. B135537
    Remove the rear door opening trim.


20. REMOVE ACCESS PANEL CHECK ASSEMBLY

B135538
  1. Remove the bolt and 2 nuts, then remove the access panel check.

    NOTICE:
    Do not drop or damage the access panel check when removing the bolt and nuts.

    HINT:
    Remove the access panel check through the service hole.


21. REMOVE ACCESS PANEL WEATHERSTRIP

  1. B373587
    Using a clip remover, remove the 7 clips.

  1. Using a clip remover, disengage the 19 clips.

  1. Peel off all the double-sided tape to remove the access panel weatherstrip.


22. REMOVE ACCESS PANEL LOWER LOCK STOP

B135945
  1. Using "Torx" socket wrench T40, remove the 2 screws and access panel lower lock stop.


23. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY

HINT:
Use the same procedure as for the LH side (Click here).


24. REMOVE ACCESS DOOR GLASS OUTER WEATHERSTRIP

HINT:
Use the same procedure as for the LH side (Click here).


25. REMOVE REAR DOOR GLASS

HINT:
Use the same procedure as for the LH side (Click here).

← COMPONENTS (from Jul 2007)DISASSEMBLY (from Nov 2010) →