INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| 1. PRECAUTION |
- CAUTION:
- Read "PRECAUTION" thoroughly before servicing (Click here).
| 2. INSTALL SEAT POSITION SENSOR |
Check that the ignition switch is turned to OFF.
Check that the negative (-) battery terminal is disconnected.
- CAUTION:
- After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
Install the seat position sensor with the bolt.

- Torque:
- 3.9 N*m{ 40 kgf*cm , 35 in.*lbf }
Check that there is no looseness in the installation parts of the seat position sensor.
Connect the connector to the seat position sensor.
| 3. INSTALL FRONT SEAT ASSEMBLY LH |
![]() ![]() |
- NOTICE:
- Follow the procedure described below in order to prevent the seat tracks from locking separately.
Insert the 2 locating pins through the 2 body holes, place the front seat in the most rearward position and make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 1 and then bolt 2 onto the front side.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Move the front seat to the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 3 and then bolt 4 onto the rear side.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.
- HINT:
- If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.
for Driver Side:

Connect the 2 buckle switch connectors.
w/ Front Seat Side Airbag:
- Connect the airbag connector.
- Connect the airbag connector.
Install the clamp.
for Front Passenger Side:

Connect the connector.
w/ Front Seat Side Airbag:
- Connect the airbag connector.
- Connect the airbag connector.
Install the clamp.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 3.9 N*m{ 40 kgf*cm , 35 in.*lbf }
| 5. PERFORM INITIALIZATION |
Perform initialization (Click here).
- HINT:
- Some systems need initialization when disconnecting the cable from the negative battery terminal.
| 6. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).

