2011-2016 FJ Cruiser · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).


2. INSTALL SEAT POSITION SENSOR
  1. Check that the ignition switch is turned to OFF.

  1. Check that the negative (-) battery terminal is disconnected.

    CAUTION:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

  1. C128270
    Install the seat position sensor with the bolt.

    Torque:
    3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

  1. Check that there is no looseness in the installation parts of the seat position sensor.

  1. Connect the connector to the seat position sensor.


3. INSTALL FRONT SEAT ASSEMBLY LH

B130666E01

NOTICE:
Follow the procedure described below in order to prevent the seat tracks from locking separately.

  1. Insert the 2 locating pins through the 2 body holes, place the front seat in the most rearward position and make sure that the inner and outer seat tracks are locked securely.

  1. Tighten bolt 1 and then bolt 2 onto the front side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Move the front seat to the most forward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Tighten bolt 3 and then bolt 4 onto the rear side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.

    HINT:
    If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

  1. B135118
    for Driver Side:

    1. Connect the 2 buckle switch connectors.

    2. w/ Front Seat Side Airbag:

      1. Connect the airbag connector.

    3. Install the clamp.

  1. B177957
    for Front Passenger Side:

    1. Connect the connector.

    2. w/ Front Seat Side Airbag:

      1. Connect the airbag connector.

    3. Install the clamp.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when disconnecting the cable from the negative battery terminal.


6. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).

← REMOVAL (from Aug 2012)INSTALLATION (Nov 2010 – Jul 2012) →