REMOVAL
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| 1. PRECAUTION |
- CAUTION:
- Read "PRECAUTION" thoroughly before servicing (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
| 3. REMOVE FRONT SEAT ASSEMBLY LH |
for Driver Side:

Using a clip remover, remove the clamp.
Disconnect the 2 buckle switch connectors.
w/ Front Seat Side Airbag:
- Slide the slider and disconnect the airbag connector.
- Slide the slider and disconnect the airbag connector.
for Front Passenger Side:

Using a clip remover, remove the clamp.
Disconnect the connector.
w/ Front Seat Side Airbag:
- Slide the slider and disconnect the airbag connector.
- Slide the slider and disconnect the airbag connector.
Move the front seat to the most forward position.

Remove the 2 bolts from the rear side.
Move the front seat to the most rearward position.
Remove the 2 bolts from the front side.
Remove the front seat.
| 4. REMOVE SEAT POSITION SENSOR |
Disconnect the connector from the seat position sensor.
Remove the bolt and the seat position sensor.

