Use the same procedures for the RH side and LH side.
The procedures described below are for the LH side.
1.
PRECAUTION
CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).
2.
INSTALL SIDE AIRBAG SENSOR LH
Check that the ignition switch is turned to OFF.
Check that the negative (-) battery terminal is disconnected.
CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
Install the side airbag sensor LH with the bolt.
Torque:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
NOTICE:
If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the side airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.
Check that there is no looseness in the installation parts of the side airbag sensor LH.
Connect the connector to the side airbag sensor LH.
3.
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Align the locating marks with the paint marks first, and install the front door opening trim weatherstrip, as shown in the illustration.
Paint mark:
Area
Color
RH side
White
LH side
Red
4.
INSTALL ACCESS DOOR SCUFF PLATE LH
Engage the 6 claws and install the access door scuff plate.
5.
INSTALL FRONT DOOR SCUFF PLATE LH
Engage the 14 claws and install the door scuff plate.