2011-2016 FJ Cruiser · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.


1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).


2. INSTALL SIDE AIRBAG SENSOR LH
  1. Check that the ignition switch is turned to OFF.

  1. Check that the negative (-) battery terminal is disconnected.

    CAUTION:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

  1. C128265
    Install the side airbag sensor LH with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the side airbag sensor LH.

  1. C128264E01
    Connect the connector to the side airbag sensor LH.


3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side.


4. INSTALL ACCESS DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side.


5. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when the cable has been disconnected from the negative battery terminal.


8. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).

← INSTALLATION (Jul 2007 – Oct 2010)INSTALLATION (from Aug 2012) →