2011-2016 FJ Cruiser · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.


1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).


2. INSTALL FRONT AIRBAG SENSOR LH
  1. Check that the ignition switch is turned to OFF.

  1. Check that the negative (-) battery terminal is disconnected.

    CAUTION:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

  1. C141567E01
    Connect the connector to the front airbag sensor LH.

  1. C128245
    Install the front airbag sensor LH with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
    2. When installing the front airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the front airbag sensor LH.


3. INSTALL FRONT BUMPER COVER

  1. B138601
    Install the 4 clips.

  1. B134733
    Engage the 2 claws and install the front bumper cover.

  1. B134732
    Tighten the 8 screws and the 4 bolts.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf } for screw
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf } for bolt

  1. B138606
    Install the 5 clips.

  1. B134730E01
    Remove the protective tape.


4. INSTALL RADIATOR GRILLE

  1. B134729
    Engage the 5 clips and install the radiator grille.

  1. Tighten the 2 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }

  1. Install the 2 clips.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when the cable has been disconnected from the negative battery terminal.


7. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).

← REMOVAL (from Aug 2014)INSTALLATION (Nov 2010 – Jul 2012) →